Nullifire SC802 Water-based Intumescent Coating 25kg 60 Minutes

• Water based intumescent coating suitable for internal use on structural steelwork for up to 60 minute fire resistance
• “Next generation” product – with greater efficiency on site
• Compatible with a full range of Nullifire primers and top seals
• Very low VOC

Application Conditions

• Nullifire SC802 is recommended for application and use on dry protected structural steel only.
• If the basecoat is allowed to get wet, it is likely to be damaged – blistering and wrinkling may occur.
• SC802 should only be applied when the air and steel temperatures are above 5°C. Relative humidity should be below 80% for successful application. Steel surface temperature should be a minimum of 3°C above the dew point.
• Ensure the steel is dry and free from contact with rain or condensation during the application and drying of SC802.

Surface Preparation & Priming

• SC802 should be applied onto a clean, undamaged, dry and primed steel surface.
• Certain types of primers can cause char adhesion problems in a fire. In particular, thermoplastic primers must be avoided.
• Nullifire recommend and have tested PM015, PM019 and PM020 primers – see website for details.
• Nullifire have carried out compatibility testing on a wide range of primers. Contact our technical team for details on compatibility.
• SC802 should not be applied directly to galvanised surfaces or zinc rich primer.
• The primer must be applied in accordance with the manufacturer’s instructions.
• Nullifire should be consulted for technical advice when zinc rich primers or the overcoating of existing paints are specifed for use.